If you want to install an MPC expansion bought on the MPC Store, I invite you to watch this video:
But if you downloaded an expansion from a third-party site or you have a backup (safety copy) of an MPC expansion on a USB stick, an SD card or an SSD, here is the simple, effective method to install it on your standalone MPC (Key 37, Live 2, X, One…).
Prerequisites
- A valid MPC expansion (a folder containing
.xpm,.xpk,.wavfiles, etc.) - A storage device: an external USB stick, SD card, or SSD
- The device must be formatted as exFAT
Steps to manually install an MPC expansion (third-party or backup)
1. Insert your storage device into the MPC
Insert your USB stick, SD card or external SSD into the MPC, switched off or on (it doesn’t matter at this point). Make sure it’s formatted as exFAT: it’s the only format the MPC can read.
2. Connect your storage device to your computer
– Directly through a port (USB, SD card) on your computer. The device will show up as an external hard drive.
– Or through the MPC, by connecting it to your computer
- Connect your MPC to your computer over USB.
- Switch the MPC on and put it in “Controller” mode.
- You’ll then see the device show up as an external drive on your computer.
3. Create an “Expansions” folder
On the storage device (USB stick, SD, SSD), create a folder named exactly:
Expansions
Expansions
This folder must be at the root of the device (not inside another folder).
4. Paste the expansion into the right folder
Copy and paste your expansion’s folder (the one containing the sounds, programs, etc.) into the “Expansions” folder.
So you should end up with a folder tree like this:
/Expansions/
MonNomDExpansion/
Programs/
Samples/
etc.
Don’t paste the files directly into “Expansions” without their own folder.
5. Disconnect cleanly and go back to standalone
- Eject the device cleanly from your computer.
- Unplug the USB cable if needed.
- Put your MPC in standalone mode.
6. Open the expansion from the MPC
- On your MPC, open the Browser (Menu > Browser)
- Go to the Expansions tab
- You should see your expansion appear
- You can now load the kits, keygroups or projects it includes
What if it doesn’t show up?
A few useful checks:
- Make sure the folder name doesn’t contain any special characters.
- Check that the folder really contains files the MPC can read (
.xpm,.xpk,.wav, etc.). - Try renaming or restructuring the subfolders if the expansion doesn’t show up properly.
In short
Downloaded somewhere else? You put it manually in an “Expansions” folder on your USB stick or SD card. You start the MPC in standalone… and it’s ready to use.


Leave a Reply